The difference between a rod making machine and a toner forming machine

Many customers who make charcoal have very different raw materials. Some are close to mountain forests, there are branches and bark in mountain forests, there are straws from rural fields, there are some sawdust shavings recovered from wood factories, and some people's raw materials It is not wood material, but charcoal powder. The charcoal powder made into charcoal is different from other raw materials.

Two types of equipment will be mentioned here: rod making machine and carbon powder molding machine. Consumers often have some doubts when buying the molding machine. They are not clear about the difference and purpose of the two types of charcoal equipment. Gongyi Hengxin Charcoal Machine General Manager The factory will let you know the difference between the rod making machine and the toner forming machine.

rod making machine

1. The stick making machine is specialized in producing charcoal sticks.

2. Carbon powder forming machine is specialized in forming carbon powder and coal powder.

The stick making machine combines sawn wood, branches, rice husks, bamboo shavings, peanut husks, sunflower seed husks, distiller’s grains, bagasse, corn cobs, coconut husks, coffee grounds and crop straws, yam grass, dead leaves and other agricultural and forestry wastes. As the raw material, after drying and de-smoke, high-quality, environmentally friendly and efficient mechanism charcoal rods are made at high temperature and pressure, and finally put into the carbonization furnace to burn machine-made charcoal.

The carbon powder molding machine is a machine that uses coal powder, carbon powder, binder, and water to make charcoal through the molding machine, and does not need to be burned in the carbonization furnace.

In recent years, many customers have called to inquire about carbon powder molding problems. In fact, carbon powder molding is not difficult. It also needs an auxiliary machine, which is a mixer, because the carbon powder must be crushed before it is made. Then add water and stir evenly, this work needs to be carried out by a mixer.

In short, the toner forming machine and the charcoal rod making machine are both good equipment for recycling waste and environmental protection. The machine-made carbon produced can be used in many fields such as chemical industry, production, and life. Customers should combine the characteristics of their own raw materials to be flexible when purchasing. grasp.