What are the common problems of mechanism charcoal machine?

The mechanism charcoal machine is an environmental protection equipment that uses my country's biomass waste production mechanism charcoal. It has high production efficiency and good quality, and the mechanism charcoal produced can be widely used in the market and has been favored by the majority of users. Recently, users are operating There will also be some failures when the mechanism charcoal machine is used, so what are the common problems of the mechanism charcoal machine? How to solve the common problems of the charcoal machine?

1. The power indicator light of the console is off

Reasons: ①The mechanism charcoal machine is not connected to the power supply; ②The fuse is blown; ③The indicator light is broken.

Corrective measures: ①Connect the power cord of the mechanism charcoal machine; ②Replace the fuse; ③Replace the indicator lamp.

2. The mechanism charcoal machine motor does not start

Reasons: ①The control button of the mechanism charcoal machine is damaged; ②One phase is missing; ③The voltage and frequency do not match.

Corrective measures: ①Replace the control button of the mechanism charcoal machine; ②Connect the power cord; ③Check the voltage frequency.

3. The heating temperature rises slowly and does not reach 350 degrees

Reasons: ①The power supply voltage of the mechanism charcoal machine is low; ②The resistance heating coil of the mechanism charcoal machine is damaged; ③The model of the mechanism charcoal machine is wrong when replacing the heating coil wire.

Corrective measures: ①Check the voltage of the mechanism charcoal machine; ②Replace the resistance heating coil of the mechanism charcoal machine; ③Replace the wire of the mechanism charcoal machine as required.

4. The motor heats up

Reasons: ①The load of the mechanism charcoal machine is too large; ②The two-phase operation of the mechanism charcoal machine; ③The bearing of the mechanism charcoal machine is damaged; ④The air duct of the mechanism charcoal machine is blocked; ⑤The ambient temperature of the mechanism charcoal machine is high; Mechanism charcoal machine rotor winding or indirect short circuit.

Corrective measures: ① Check the supply of materials for the mechanism charcoal machine; ② Check the wires, switches, and contacts of the mechanism charcoal machine; ③ Replace the bearings of the mechanism charcoal machine and add lubricating oil; ④ Clear the debris of the mechanism charcoal machine and dredge the air duct; ⑤ Take Cooling measures; ⑥Adjust the voltage of the mechanism charcoal machine; ⑦Check and rule out.

5. The machine is not good

Reasons: ①The raw material humidity of the mechanism charcoal machine is too high; ②The heating temperature of the charcoal machine is low; ③The material is sandwiched in the spiral groove of the charcoal machine; ④The groove in the heating cylinder of the charcoal machine is misaligned with the groove of the heating cylinder; ⑤The voltage of the charcoal machine is low ; ⑥ The inner sleeve of the charcoal machine bracket is worn; ⑦ The inner sleeve of the charcoal machine heating cylinder is worn; ⑧ The screw propeller of the mechanism charcoal machine is worn.

Corrective measures: ①Heat the raw materials as required; ②Increase the heating temperature; ③Clear the miscellaneous materials in the spiral groove of the mechanism charcoal machine; ④Reinstall the inner sleeve of the heating cylinder; ⑤Check the voltage; ⑥Replace the inner sleeve; ⑦Replace the inner sleeve of the heating cylinder; ⑧Repair or replace the screw propeller.

The above are the common problems and solutions of the mechanism charcoal machine in the process of producing mechanism charcoal. The manufacturer of the mechanism charcoal machine recommends that the majority of users should maintain it when operating the equipment to avoid its failure. When the equipment fails It is necessary to solve it in time, so as to ensure the smooth production of the mechanism charcoal machine.