The three most common faults and solutions for charcoal rod making machines

The charcoal rod making machine is responsible for the forming of the fuel rods on the entire charcoal production line, and only the fuel rods are qualified can the last step of carbonization work, so the importance of the charcoal rod making machine in the entire production line is very important. In the production of charcoal The stick making machine is also unavoidable to have various problems. Let's talk about the three most common faults and solutions of the charcoal stick making machine.

Charcoal Product Line

1. The rod making machine does not produce rods. The reason is that the heating temperature is too high or too low, the forming sleeve of the rod making machine is worn seriously, the angle of the screw propeller is not consistent, and the raw material moisture is too large. Our company's charcoal machine adopts automatic temperature control device, and the molding sleeve is made of high alloy material, which is resistant to compression and wear.

2. The fuel rod does not form because of improper temperature control, excessive moisture in the raw material, worn out of the propeller of the rod making machine, improper shaft tip, clogged vent, too large or too small screw of the head of the rod making machine, sleeve Serious wear, etc.

3. The quality of salary stick is not high. Excessive moisture in the raw material will easily cause transverse cracks in the bar, and too little moisture will easily cause longitudinal cracks. In addition, the heating temperature is too high, the raw material will be excessively softened, resulting in insufficient material supply, which can also lead to cracks. If the feed barrel is insufficiently supplied, the diameter of the spiral can be appropriately increased, or the spiral wall can be polished to increase the pitch between the spirals.