What problems will you encounter in the work of the charcoal machine?

The charcoal machine is a machine that pulverizes the sawdust into granules within 10mm by the sawdust pulverizer, which is dried by a dryer and then placed in a carbonization furnace for carbonization. Fully automatic charcoal machines often encounter some debugging problems, how do you solve them? The following editor will share with you several methods for correct startup and debugging of charcoal machines.

charcoal machine
 

The debugging method of the automatic charcoal machine to start correctly

1. All connecting screws of the charcoal machine must be tightened, especially the three top shafts of the heating drum.

2. After ensuring the stability of the equipment, check all the smooth parts of the equipment, such as the rod making machine, grinder, dryer, etc., and add gear oil to ensure the smooth operation of the equipment.

3. Connect the main control box power supply and adjust the safety wiring. At this time, don't start the machine lightly. You can start a three to five minute silence to see if there are any abnormal phenomena, such as cards, bumps, etc. If not, you can put them into normal production and use. Once the above situation occurs, the inspection must be stopped immediately to completely clear the fault.

4. The new machine needs to ensure that the equipment warms up slowly. Only when the temperature rises, the machine can start and enter.

5. During the feeding process, remember not to be too fast. When the automatic charcoal machine can be turned off for 30 minutes and then run normally, it now shows that the test run has been successful and normal production can be carried out.