Three common faults and solutions of charcoal rod making machine

The charcoal rod making machine is responsible for the forming of the fuel rods on the entire charcoal production line, and only the fuel rods are qualified for the subsequent carbonization work, so the importance of the charcoal rod making machine in the entire production line is very important. In the production of charcoal It is inevitable that there will be various problems with the stick making machine. Let's talk about the three common faults and solutions of the charcoal stick making machine.

charcoal rod making machine

1. The rod making machine does not produce rods. The reason is that the heating temperature is too high or too low, the forming sleeve of the rod making machine is worn more seriously, the angle of the screw propeller is not consistent, and the raw material has too much moisture. Our company's charcoal machine adopts automatic temperature control device, and the molding sleeve is made of high-alloy material, which is compressive and wear-resistant.

2. The fuel rod does not form because of improper temperature control, excessive moisture in the raw material, worn out of the propeller of the rod making machine, improper shaft tip, clogged vent, the screw of the head of the rod making machine's propeller is too large or too small, and the sleeve Serious wear, etc.

3. The quality of salary stick is not high. Excessive moisture in the raw material will easily cause transverse cracks in the bar, and too little moisture will easily cause longitudinal cracks. In addition, the heating temperature is too high, the raw material will be excessively softened, resulting in insufficient material supply, which will also lead to the generation of cracks. If the feed barrel is insufficiently supplied, the diameter of the spiral can be appropriately increased, or the spiral wall can be polished to increase the pitch between the spirals.